Ip Interface Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Table 121 L3 Configuration Menu options
Command
*frwd
*nwf <1-256>
*rmap <1-32>
*rip
*ospf
igmp
dns
*bootp
*vrrp
cur
* indicates menus that are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

IP interface configuration

Command: /cfg/l3/if <1-256>
[IP Interface 1 Menu]
addr
mask
vlan
ena
dis
del
cur
The switch can be configured with up to 256 IP interfaces. Each IP interface represents the switch on an IP subnet on
your network. The IP Interface option is disabled by default.
The following table describes the IP Interface Configuration Menu options.
Table 122 IP Interface Configuration Menu options
Command
addr <IP address>
mask <IP subnet mask>
vlan <1-4095>
ena
dis
del
cur
NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
Description
Displays the IP Forwarding Menu.
Displays the Network Filter Configuration Menu.
Displays the Route Map Menu.
Displays the Routing Interface Protocol Menu.
Displays the OSPF Menu.
Displays the IGMP Menu.
Displays the IP Domain Name System Menu.
Displays the Bootstrap Protocol Menu.
Displays the Virtual Router Redundancy Configuration Menu.
Displays the current IP configuration.
- Set IP address
- Set subnet mask
- Set VLAN number
- Enable IP interface
- Disable IP interface
- Delete IP interface
- Display current interface configuration
Description
Configures the IP address of the switch interface, using dotted decimal notation. For
example, 192.2.14.101
Configures the IP subnet address mask for the interface using dotted decimal
notation. For example, 255.255.255.0
Configures the VLAN number for this interface. Each interface can belong to one
VLAN, though any VLAN can have multiple IP interfaces in it.
Enables this IP interface.
Disables this IP interface.
Removes this IP interface.
Displays the current interface settings.
Configuration Menu 123