Bridge Spanning Tree Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The following table describes the Spanning Tree Configuration Menu options.
Table 110 Spanning Tree Configuration Menu options
Command
brg
port <port number>
add <1-4095>
remove <1-4095>
clear
on
off
default
cur

Bridge Spanning Tree configuration

Command: /cfg/l2/stp/brg
[Bridge Spanning Tree Menu]
Spanning tree bridge parameters can be configured for each Spanning Tree Group. STP bridge parameters include:
Bridge priority
Bridge hello time
Bridge maximum age
Forwarding delay
Current bridge configuration
The following table describes the Bridge Spanning Tree Configuration Menu options.
Table 111 Bridge Spanning Tree Configuration Menu options
Command
prior <0-65535>
hello <1-10>
Description
Displays the Bridge Spanning Tree Menu.
Displays the Spanning Tree Port Menu.
Associates a VLAN with a spanning tree and requires an external VLAN ID as a
parameter.
Breaks the association between a VLAN and a spanning tree and requires an
external VLAN ID as a parameter.
Removes all VLANs from a spanning tree.
Globally enables Spanning Tree Protocol.
Globally disables Spanning Tree Protocol.
Restores a spanning tree instance to its default configuration.
Displays current Spanning Tree Protocol parameters.
prior - Set bridge Priority [0-65535]
hello - Set bridge Hello Time [1-10 secs]
mxage - Set bridge Max Age (6-40 secs)
fwd - Set bridge Forward Delay (4-30 secs)
cur - Display current bridge parameters
Description
Configures the bridge priority. The bridge priority parameter controls which bridge on the
network is the STP root bridge.
To make this switch the root bridge, configure the bridge priority lower than all other switches
and bridges on your network. The lower the value, the higher the bridge priority. The range is 0
to 65535, and the default is 32768.
RSTP/MSTP: The range is 0 to 61440, in steps of 4096 (0, 4096, 8192...), and the default is
32768.
This command does not apply to MSTP. See the "Common Internal Spanning Tree configuration"
section for more information.
Configures the bridge hello time. The hello time specifies how often the root bridge transmits a
configuration bridge protocol data unit (BPDU).
Any bridge that is not the root bridge uses the root bridge hello value. The range is 1 to 10
seconds, and the default is 2 seconds.
This command does not apply to MSTP. See the "Common Internal Spanning Tree configuration"
section for more information.
Configuration Menu 116