Ip Interface Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

IP interface configuration

Command: /cfg/l3/if <1-250>
[IP Interface 1 Menu]
The switch can be configured with up to 250 IP interfaces. Each IP interface represents the switch on
an IP subnet on your network. The IP Interface option is disabled by default.
The following table describes the IP Interface Configuration Menu options.
Table 130
IP Interface Configuration Menu options
Command
addr <IP address>
mask <IP subnet mask>
vlan <1-4094>
relay disable|enable
ena
dis
del
cur
NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
addr - Set IP address
mask - Set subnet mask
vlan - Set VLAN number
relay - Enable/disable BOOTP relay
ena - Enable IP interface
dis - Disable IP interface
del - Delete IP interface
cur - Display current interface configuration
Description
Configures the IP address of the switch interface, using dotted decimal
notation. For example, 192.2.14.101
Configures the IP subnet address mask for the interface using dotted
decimal notation. For example, 255.255.255.0
Configures the VLAN number for this interface. Each interface can belong
to one VLAN, though any VLAN can have multiple IP interfaces in it.
Enables or disables the BOOTP relay on this interface. The default value is
enabled.
Enables this IP interface.
Disables this IP interface.
Removes this IP interface.
Displays the current interface settings.
Configuration Menu 159