Rip User Configuration; Ip Information; Igmp Multicast Group Information - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

RIP user configuration

NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Command: /info/l3/rip/dump <1-255>
RIP USER CONFIGURATION :
RIP on updat 30
RIP Interface 2 : 102.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
auth none,key none
RIP Interface 3 : 103.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1

IP information

Command: /info/l3/ip
Interface information:
1: 47.80.23.243
Default gateway information:
1: 47.80.22.1,
2: 47.80.225.2,
Current BOOTP relay settings: OFF
0.0.0.0, 0.0.0.0
Current IP forwarding settings: OFF, dirbr disabled
Current network filter settings:
none
Current route map settings:
The following interface and default gateway information is displayed (some fields apply only to the GbE2c Layer 2/3
Ethernet Blade Switch):
Interface number
IP address
IP mask
IP broadcast address
Operational status
BootP relay settings
IP forwarding settings
Network filter settings
Route map settings

IGMP multicast group information

Command: /info/l3/igmp
[IGMP Multicast Group Menu]
The following table describes the commands used to display information about IGMP groups learned by the switch.
Table 35 IGMP Multicast Group menu options
255.255.254.0
up
up
mrouter - Show IGMP Snooping Multicast Router Port information
find - Show a single group by IP group address
vlan - Show groups on a single vlan
port - Show groups on a single port
trunk - Show groups on a single trunk
dump - Show all groups
47.80.23.255, up
Information Menu 51