Port Acl/Qos Configuration; Layer 2 Configuration; 802.1X Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Port ACL/QoS configuration

Command: /cfg/port <port number>/aclqos
[Port 20 ACL Menu]
add
rem
cur
The following table describes the port ACL/QoS Configuration Menu options.
Table 101 Port ACL/QoS Configuration Menu options
Command
add acl <1-762>| grp <1-762>
rem acl <1-762>| grp <1-762>
cur

Layer 2 configuration

Command: /cfg/l2
[Layer 2 Menu]
8021x
mrst
stp
fdb
trunk
thash
lacp
vlan
upfast
update
cur
The following table describes the Layer 2 Configuration Menu options.
Table 102 L2 Configuration Menu options
Command
8021x
mrst
stp
fdb
trunk <1-12>
thash
lacp
vlan <1-4095>
upfast enable|disable
update <10-200>
cur

802.1x configuration

Command: /cfg/l2/8021x
- Add ACL or ACL group to this port
- Remove ACL or ACL group from this port
- Display current ACLs for this port
Description
Assigns an ACL or ACL Group to the port.
Removes an ACL or ACL Group from the port.
Displays current port ACL/QoS parameters.
- 802.1x Menu
- Multiple Spanning Tree/Rapid Spanning Tree Menu
- Spanning Tree Menu
- FDB Menu
- Trunk Group Menu
- IP Trunk Hash Menu
- Link Aggregation Control Protocol Menu
- VLAN Menu
- Enable/disable Uplink Fast
- UplinkFast station update rate
- Display current layer 2 parameters
Description
Displays the 802.1x Configuration Menu.
Displays the Rapid Spanning Tree/Multiple Spanning Tree Protocol Configuration Menu.
Displays the Spanning Tree Configuration Menu.
Displays the Forwarding Database Configuration Menu.
Displays the Trunk Group Configuration Menu for the selected trunk (1-12).
Displays the IP Trunk Hash Menu.
Displays the Link Aggregation Control Protocol Menu.
Displays the VLAN Configuration Menu.
Enables or disables Fast Uplink Convergence, which provides rapid Spanning Tree
convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all STGs and
path cost by 3000 for all external STP ports.
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
Displays current Layer 2 parameters.
Configuration Menu 109