Route Map Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The following table describes the Network Filter Configuration Menu options.
Table 127 Network Filter Configuration Menu options
Command
addr <IP address>
mask <IP subnet mask>
enable
disable
delete
current

Route Map configuration

Command: /cfg/l3/rmap <1-32>
[IP Route Map 1 Menu]
alist
aspath
ap
lp
metric
type
prec
weight
enable
disable
delete
current
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Routing maps control and modify routing information. The map number (1-32) represents the routing map you wish to
configure.
The following table describes the Route Map Configuration Menu options.
Table 128 Route Map Configuration Menu options
Command
alist <1-8>
aspath <1-8>
ap <AS number> [<AS number>] [<AS
number>]|none
lp <0-4294967294>|none
metric <0-4294967294>|none
type 1|2|none
prec <1-256>
weight <0-65534>|none
Description
Sets the starting IP address for this filter. The default address is 0.0.0.0
Sets the IP subnet mask that is used with
range of IP addresses that will be accepted by the peer when the filter is
enabled. The default value is 0.0.0.0
Enables the Network Filter configuration.
Disables the Network Filter configuration.
Deletes the Network Filter configuration.
Displays the current the Network Filter configuration.
- Access List number
- AS Filter Menu
- Set as-path prepend of the matched route
- Set local-preference of the matched route
- Set metric of the matched route
- Set OSPF metric-type of the matched route
- Set the precedence of this route map
- Set weight of the matched route
- Enable route map
- Disable route map
- Delete route map
- Display current route map configuration
Description
Displays the Access List menu.
Displays the Autonomous System (AS) Filter menu.
Sets the AS path preference of the matched route. One to three path
preferences can be configured.
Sets the local preference of the matched route, which affects both
inbound and outbound directions. The path with the higher preference is
preferred.
Sets the metric of the matched route.
Assigns the type of OSPF metric. The default is type 1.
Type 1—External routes are calculated using both internal and
external metrics.
Type 2—External routes are calculated using only the external
metrics. Type 2 routes have more cost than Type 2.
none
Sets the precedence of the route map. The smaller the value, the higher
the precedence. Default value is 10.
Sets the weight of the route map.
/cfg/l3/nwf/addr
—Removes the OSPF metric.
to define the
Configuration Menu 126