First-Time Configuration Introduction; Configuring Simple Network Management Protocol Support - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

First-time configuration
Introduction
This chapter describes how to perform first-time configuration and how to change system passwords.
To begin first-time configuration of the switch, perform the following steps.
1. Connect to the switch console. After connecting, the login prompt displays.
GbE2c Ethernet Blade Switch for HP c-Class Blade System.
Copyright(C)2006 Hewlett-Packard Development Company, L.P.
Password:
2. Enter admin as the default administrator password.
The system displays the Main Menu with administrator privileges.
[Main Menu]
info
stats
cfg
oper
boot
maint
diff
apply
save
revert
exit
>> Main#
3. From the Main Menu, enter the following command to access the Configuration Menu:
Main# /cfg
The Configuration Menu is displayed.
[Configuration Menu]
sys
port
l2
l3
qos
acl
rmon
pmirr
ufd
dump
ptcfg
gtcfg
cur

Configuring Simple Network Management Protocol support

NOTE: SNMP support is enabled by default.
1. Use the following command to enable SNMP:
>> # /cfg/sys/access/snmp disable|read only|read/write
2. Set SNMP read or write community string. By default, they are public and private respectively:
>> # /cfg/sys/ssnmp/rcomm|wcomm
3. When prompted, enter the proper community string.
4. Apply and save configuration if you are not configuring the switch with Telnet support. Otherwise apply and
save after the performing the "Optional Setup for Telnet Support" steps.
- Information Menu
- Statistics Menu
- Configuration Menu
- Operations Command Menu
- Boot Options Menu
- Maintenance Menu
- Show pending config changes
- Apply pending config changes [global command]
- Save updated config to FLASH [global command]
- Revert pending or applied changes [global command]
- Exit [global command, always available]
- System-wide Parameter Menu
- Port Menu
- Layer 2 Menu
- Layer 3 Menu
- QOS Menu
- Access Control List Menu
- RMON Menu
- Port Mirroring Menu
- Uplink Failure Detection Menu
- Dump current configuration to script file
- Backup current configuration to FTP/TFTP server
- Restore current configuration from FTP/TFTP server
- Display current configuration
[global command]
First-time configuration 18