Ospf Interface Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The following table describes the OSPF Summary Range Configuration Menu options.
Table 136 OSPF Summary Range Configuration Menu options
Command
addr <
IP Address
mask <
IP address mask
aindex <
0-2
hide disable|enable
enable
disable
delete
cur

OSPF Interface configuration

Command: /cfg/l3/ospf/if <1-256>
[OSPF Interface 1
aindex
prio
cost
hello
dead
trans
retra
key
mdkey
enable
disable
delete
cur
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the OSPF Interface Configuration Menu options.
Table 137 OSPF Interface Configuration Menu options
Command
aindex <0-2>
prio <0-255>
cost <1-65535>
hello <1-65535>
dead <1-65535>
trans <1-3600>
retra <1-3600>
key <key string>|none
mdkey <1-255>|none
enable
Description
Configures the base IP address for the range. For example,
>
100.10.1.1
Configures the IP address mask for the range.
>
Configures the area index used by the switch.
>
Hides the OSPF summary range.
Enables the OSPF summary range.
Disables the OSPF summary range.
Deletes the OSPF summary range.
Displays the current OSPF summary range.
Menu]
- Set area index
- Set interface router priority
- Set interface cost
- Set hello interval in seconds
- Set dead interval in seconds
- Set transit delay in seconds
- Set retransmit interval in seconds
- Set authentication key
- Set MD5 key ID
- Enable interface
- Disable interface
- Delete interface
- Display current OSPF interface configuration
Description
Configures the OSPF area index.
Configures the assigned priority value to the OSPF interfaces.
(A priority value of 127 is the highest and 1 is the lowest. A priority value of 0
specifies that the interface cannot be used as Designated Router (DR) or Backup
Designated Router (BDR).)
Configures cost set for the selected path—preferred or backup. Usually the cost
is inversely proportional to the bandwidth of the interface. Low cost indicates
high bandwidth.
Configures the interval in seconds between the hello packets for the
interfaces.
Configures the health parameters of a hello packet, which is set for an
interval of seconds before declaring a silent router to be down.
Configures the transit delay in seconds.
Configures the retransmit interval in seconds.
Sets the authentication key to clear the password.
Assigns an MD5 key to the interface.
Enables the OSPF interface.
Configuration Menu 133