Ospf Virtual Link Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

Table 137 OSPF Interface Configuration Menu options
Command
disable
delete
cur

OSPF Virtual Link configuration

Command: /cfg/l3/ospf/virt <1-3>
[OSPF Virtual Link 1
aindex
hello
dead
trans
retra
nbr
key
mdkey
enable
disable
delete
cur
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the OSPF Virtual Link Configuration Menu options.
Table 138 OSPF Virtual Link Configuration Menu options
Command
aindex <0-2>
hello <1-65535>
dead <1-65535>
trans <1-3600>
retra <1-3600>
nbr <IP address>
key <password>
mdkey <1-255>|none
enable
disable
delete
cur
Description
Disables the OSPF interface.
Deletes the OSPF interface.
Displays the current settings for OSPF interface.
Menu]
- Set area index
- Set hello interval in seconds
- Set dead interval in seconds
- Set transit delay in seconds
- Set retransmit interval in seconds
- Set router ID of virtual neighbor
- Set authentication key
- Set MD5 key ID
- Enable interface
- Disable interface
- Delete interface
- Display current OSPF interface configuration
Description
Configures the OSPF area index.
Configures the authentication parameters of a hello packet, which is set
to be in an interval of seconds.
Configures the health parameters of a hello packet, which is set to be in
an interval of seconds. Default is 40 seconds.
Configures the delay in transit in seconds. Default is one second.
Configures the retransmit interval in seconds. Default is five seconds.
Configures the router ID of the virtual neighbor. Default is 0.0.0.0
Configures the password (up to eight characters) for each virtual link.
Default is
Sets MD5 key ID for each virtual link. Default is
Enables OSPF virtual link.
Disables OSPF virtual link.
Deletes OSPF virtual link.
Displays the current OSPF virtual link settings.
.
none
.
none
Configuration Menu 134