Ntp Server Configuration; System Snmp Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

NTP server configuration

Command: /cfg/sys/ntp
[NTP Server Menu]
prisrv
secsrv
intrval
tzone
dlight
on
off
cur
This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By default, this
option is disabled.
The following table describes the NTP Server Configuration Menu options.
Table 83 NTP Server Configuration Menu options
Command
prisrv <IP address>
secsrv <IP address>
intrval <1-44640>
tzone <hh:mm>
dlight disable|enable
on
off
cur

System SNMP configuration

Command: /cfg/sys/ssnmp
[SNMP Menu]
snmpv3
name
locn
cont
rcomm
wcomm
timeout
auth
linkt
ufd
cur
The switch software supports SNMP-based network management. In SNMP model of network management, a
management station (client/manager) accesses a set of variables known as MIBs (Management Information Base)
provided by the managed device (agent). If you are running an SNMP network management station on your network,
you can manage the switch using the following standard SNMP MIBs:
MIB II (RFC 1213)
Ethernet MIB (RFC 1643)
Bridge MIB (RFC 1493)
An SNMP agent is a software process on the managed device that listens on UDP port 161 for SNMP messages.
Each SNMP message sent to the agent contains a list of management objects to retrieve or to modify.
- Set primary NTP server address
- Set secondary NTP server address
- Set NTP server resync interval
- Set NTP timezone offset from GMT
- Enable/Disable daylight savings time
- Turn NTP service ON
- Turn NTP service OFF
- Display current NTP configuration
Description
Configures the IP addresses of the primary NTP server to which you want to
synchronize the switch clock.
Configures the IP addresses of the secondary NTP server to which you want to
synchronize the switch clock.
Specifies the interval, that is, how often, in minutes (1-44640), to resynchronize the
switch clock with the NTP server. The default is 1440 seconds.
Configures the NTP time zone offset from Greenwich Mean Time (GMT), in hours
and minutes. The offset format is HH:MM
Disables or enables daylight saving time in the system clock. When enabled, the
switch will add an extra hour to the system clock so that it is consistent with the local
clock. By default, this option is disabled.
Enables the NTP synchronization service.
Disables the NTP synchronization service. This is the default.
Displays the current NTP service settings.
- SNMPv3 Menu
- Set SNMP "sysName"
- Set SNMP "sysLocation"
- Set SNMP "sysContact"
- Set SNMP read community string
- Set SNMP write community string
- Set timeout for the SNMP state machine
- Enable/disable SNMP "sysAuthenTrap"
- Enable/disable SNMP link up/down trap
- Enable/disable SNMP Uplink Failure Detection trap
- Display current SNMP configuration
Configuration Menu 96