Df Staple Operation Error Df; Cf Paper Entry Sensor Non Arrival Jam; Cf Eject Sensor Stay Jam; Cf Eject Sensor Non Arrival Jam - Kyocera FS-C8600DN Service Manual

Code Contents
7000 DF staple operation error DF staple sensor (DFSTS) is not turned on within
7001
7100 CF paper entry sensor
non arrival jam
7110 CF paper entry sensor
stay jam
7200 CF eject sensor non
arrival jam
7210 CF eject sensor stay jam During centerfold operation, CF eject sensor (CFES) is
7300 CF eject sensor non
arrival jam
7310 CF eject sensor stay jam During three fold operation, CF eject sensor (CFES) is
7400 CF side registration sen-
sor 2 non arrival jam
7500 CF side registration sen-
sor 1 non arrival jam
7600 CF staple operation error CF staple sensor (CFSTS) is not turned on within
7700 CF paper conveying sen-
sor non arrival jam
7710 CF paper conveying sen-
sor stay jam
7800 MB eject sensor non
arrival jam
7810 MB eject sensor stay jam MB eject sensor (MBES) is not turned off within speci-
7950 Paper interval error jam
7951
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
Conditions
specified time after driving the DF staple motor
(DFSTM) (4000-sheet finisher).
DF staple sensor (DFSTS) is not turned on within
specified time after driving the DF staple motor
(DFSTM) (1000-sheet finisher).
CF paper entry sensor (CFPES) is not turned on even
if a specified time has elapsed after the machine eject
signal was received.
CF paper entry sensor (CFPES) is not turned off within
specified time of its turning on.
CF eject sensor (CFES) is not turned on within speci-
fied time since centerfold operation starts.
not turned off within specified time of its turning on.
CF eject sensor (CFES) is not turned on within speci-
fied time since three fold operation starts.
not turned off within specified time of its turning on.
CF side registration sensor 2 (CFSRS2) is not turned
on within specified time after driving the CF side regis-
tration motor 2 (CFSRM2).
CF side registration sensor 1 (CFSRS1) is not turned
on within specified time after driving the CF side regis-
tration motor 1 (CFSRM1).
specified time after driving the CF staple motor
(CFSTM).
CF paper conveying sensor (CFPCS) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
CF paper conveying sensor (CFPCS) is not turned off
within specified time of its turning on.
MB eject sensor (MBES) is not turned on even if a
specified time has elapsed after the machine eject sig-
nal was received.
fied time of its turning on.
An illegal inter-page or inter-print interval has occurred
(4000-sheet finisher).
An illegal inter-page or inter-print interval has occurred
(1000-sheet finisher).
1-4-25
2MN/2N1
Jam
location*
H
H
H
H
H
H
H
H
H
H
H
H
H
I
I
H
H