The Staple Position Is Misaligned - Kyocera TASKalfa Pro 15000c Advanced Operation Manual

Troubleshooting > Troubleshooting When Discharging Paper
Remedy 4: Adding a correction value to support thick paper
1
2
3

The staple position is misaligned

Remedy 1: Adjusting the position of the staples evenly from the center
1
2
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [18 Punch(T) Resist]
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
Item
18 Punch(T) Resist
Press the [Start] key > [Stop] key.
Cause
The center position of the
staples is misaligned.
The position of the front/back
staple is different from the
specified amount.
[Home] key > [...] > [Professional Settings] > [246 Adjust
Finisher] > [01 Finisher] > [08 Staple HP]
Adjust the setting value using [+], [-] key and numeric keypad.
The range of the set value is as follows.
Item
08 Staple HP
If the staple position is shifted to the front side of the machine (Sample 1), increase the set
value.
If the staple position is shifted to the rear side of the machine (Sample 2), lower the set value.
Range
-20 to 20
Corrective Actions
Remedy 1: Adjust the position of the
staples evenly from the center.
Remedy 2: Adjust the position of the front
or back staple.
Range
-30 to 30
4-59
Default Amount of change
0 0.15 mm
Reference
page 4-59
page 4-60
Default Amount of change
0 0.19 mm
Page