Chapter 1 Before Using
Installing DME Designer
To use DME Designer, you must first install the software on the computer. Before you can connect the
DME Designer software to the DME unit, send and receive configurations, or perform control, you must
first install the USB MIDI Driver or the DME-N Network Driver, according to how you will be connecting,
and then make the appropriate settings.
For instructions about how to install DME Designer and about the installation and setup method for the
MIDI driver and DME-N Network Driver, see the "DME Designer Installation Guide."
Starting DME Designer
The DME Designer software is started from the [Start] menu. DME Designer is used with one user
logged on. The user logs on when the software is started.
DME Designer Start Up and Logon (When Auto-Logon Is Not Set)
1
Click [Start]
Designer].
NOTE
In Windows2000, click [Start]
The "Log On" dialog box will be displayed.
NOTE
Automatic log-on is the default setting. If the automatic logon feature is enabled, the "Log On" dialog box will not be
displayed when the application is started. Instead, the auto-logon user will be logged on automatically. See
for information about auto-logon.
2
Click the [ ] at the right of the [User] box, and select the user.
If no user has been created, only [Administrator] will appear in the list. When starting DME
Designer for the first time after installing, select [Administrator].
[All Programs]
[YAMAHA OPT Tools]
[Programs]
[YAMAHA OPT Tools]
[DME Designer]
[DME
[DME Designer]
[DME Designer].
DME Designer Owner's Manual
page 21
11