Yamaha DME Designer Owner's Manual page 406

Chapter 6 Component Guide
Effect Type
Dist->Delay
One input, two
output distortion
and delay effects in
series.
Multi.Filter
Two input, two
output 3-band
multi-filter (24 dB/
octave).
Stereo Reverb
Two input, two
output stereo
reverb.
406 DME Designer Owner's Manual
Parameter Setting Range
DST.Type DST1, DST2, OVD1, OVD2,
CRUNCH
Drive 0 to 100
Master 0 to 100
Tone -10 to +10
N.Gate 0 to 20
Delay 0.0 to 2725.0 ms
FB.Gain -99 to +99%
Hi.Ratio 0.1 to 1.0
Freq. 0.05 to 40.00 Hz
Depth 0 to 100%
Dly.Bal 0 to 100%
Type 1 HPF, LPF, BPF
Type 2 HPF, LPF, BPF
Type 3 HPF, LPF, BPF
Freq. 1 28.0 Hz to 16.0 kHz
Freq. 2 28.0 Hz to 16.0 kHz
Freq. 3 28.0 Hz to 16.0 kHz
Level 1 0 to 100
Level 2 0 to 100
Level 3 0 to 100
Reso. 1 0 to 20
Reso. 2 0 to 20
Reso. 3 0 to 20
Rev Time 0.3 to 99.0 s
Rev Type Hall, Room, Stage, Plate
Ini.Dly 0.0 to 100.0 ms
Hi.Ratio 0.1 to 1.0
Lo.Ratio 0.1 to 2.4
Diff. 0 to 10
Density 0 to 100%
E/R Bal. 0 to 100%
HPF THRU, 21.2 Hz to 8.00 kHz
LPF 50.0 Hz to 16.0 kHz, THRU
Function
Distortion type (DST = distortion, OVD = overdrive)
Distortion drive
Master volume
Tone control
Noise reduction
Delay time
Feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase
feedback)
High-frequency feedback ratio
Modulation speed
Modulation depth
Distortion and delay balance (0% = all distortion,
100% = all delayed distortion)
Filter 1 type: high pass, low pass, band pass
Filter 2 type: high pass, low pass, band pass
Filter 3 type: high pass, low pass, band pass
Filter 1 frequency
Filter 2 frequency
Filter 3 frequency
Filter 1 level
Filter 2 level
Filter 3 level
Filter 1 resonance
Filter 2 resonance
Filter 3 resonance
Reverb time
Reverb type
Initial delay before reverb begins
High-frequency reverb time ratio
Low-frequency reverb time ratio
Reverb diffusion (left-right reverb spread)
Reverb density
Balance of early reflections and reverb (0% = all
reverb, 100% = all early reflections)
High-pass filter cutoff frequency
Low-pass filter cutoff frequency