Yamaha DME Designer Owner's Manual page 228

Chapter 4 Designer
Method 2 Start Drawing from a Node
Right-click on a wire node, then click [Start Wire] on the displayed menu. You can start a branch
wire from the node you clicked on.
Method 3 Start Drawing from a Line Segment
Right-click on a wire line segment, then click [Start Wire] on the displayed menu. A node will be
created at the point you right-clicked, and you can start a branch wire from that node.
Drawing from Anywhere on the Sheet
Right-click the start position for drawing, the click [Start Wire] on the context menu that is
displayed. Click the location where the line should bend, then double-click at the end location to
finish drawing.
Finishing Drawing
When the hotspots or already drawn wires are connected, drawing is finished.
To finish drawing without connecting to a hotspot, use one of the following methods:
• Right-click the mouse
• Double-click
• Press the <Esc> key
Drawing also finishes if another window is made active.
228 DME Designer Owner's Manual