Yamaha DME Designer Owner's Manual page 375

One Input to All Outputs
When you click the input channel number on the left side of the matrix, the [Matrix Mixer - One Input
to All Outputs] editor window opens. One input channel and all output channels are displayed. The
input channel is the one you have clicked on in the delay mixer component editor.
1
2
3
4
5
Section
1
Input Channel
2
Phase
3
Level
4
Solo
5
On
6
Bus Send Level Level
7
On
8
Block On
9
Off
)
Nominal
!
Minimum
Input Channel Switching
The [Matrix Mixer - One Input to All Outputs] editor window displays the input channel for the
channel number clicked on in the matrix mixer component editor.
The [Channel] buttons in the [Input] section of the [Matrix Mixer - All Inputs to One Output] editor
window switch the channel group that is displayed in the window.
If you make the matrix mixer component editor active while the [Matrix Mixer- One Input to All
Outputs] editor window is displayed, and then click another input channel, that channel will be
displayed in the [Matrix Mixer - One Input to All Outputs] editor window.
One [Matrix Mixer - One Input to All Outputs] editor window is displayed for each matrix mixer
component editor.
6
7
Parameter Setting Range
--
ON/OFF
- to +10 dB
ON/OFF
ON/OFF
- to +10 dB
ON/OFF
--
--
--
--
Chapter 6 Component Guide
8
9
)
!
Function
Displays the selected input channel. Select
another channel from a menu.
Reverses the phase of the input signal.
Sets the input signal level.
Turns solo ON.
Turns input ON.
Sets the signal level for each output channel.
Turns ON the output for each output channel.
Turns ON all channel outputs. When turned
ON, the [On] button lights up.
Turns OFF all channel outputs.
Resets all output signal levels, making them
0 dB.
Resets all output signal levels, making them
- dB.
DME Designer Owner's Manual 375