Downloading The Software Individually Using The Cli - Dell PowerConnect 3324 User Manual

Enter
5
The device software is copied to the Stacking member 2. unit: the
indicates the Stacking member Unit ID to which the software is copied. The following
is an example of the information that displays:
...................Unit 2: Erased image-1
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Copy: 2744590 bytes copied in 00:01:41 [hh:mm:ss]
console# 01-Jan-2000 01:01:55 %COPY-W-TRAP: The copy operation was
completed successfully
Repeat step 5 for each Stacking member. Ensure that the software is copied to the
6
correct Stacking member Unit ID.
Enter
7
device is reset.
Enter
8
booted from Image 1 after the reboot.
Enter
9
This command will reset the whole system and disconnect your
current
session. Do you want to continue (y/n) [n]?
Enter
10
Repeat steps 2 and 3 to verify which Image files are active.
11

Downloading the Software Individually Using the CLI

This section contains instructions for individually downloading device software to each
stacking member:
• from a TFTP server to a Master Unit
• from the Master Unit to Member Units
82 C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
console# copy tftp://50.1.1.2/332448-10018.dos unit://2/image
console# boot system image-2
console# boot system unit 2 image-1
. The following message displays:
console# reload
. The device reboots.
Y
to set the Image file that is used after the
. This indicates that the device is
.
//2/image