D S C P M a p p i n g P a g e
The
For the list of the DSCP default queue settings,
NOTE: In a stacking configuration, Queue 4 is used for forwarding stacking traffic. Therefore,
assigning additional traffic to Queue 4 may interfere with stack control.
•
DSCP In—Indicates the values of the DSCP field within the incoming packet.
•
Queue—Indicates the queue to which packets with the specific DSCP value are
assigned. The values are 1-4, where one is the lowest and four is the highest value.
Mapping a DSCP value and assigning priority queue:
Open the DSCP Mapping page.
1
Select a value in the DSCP In column.
2
Define the Queue fields.
3
Click Apply Changes. The DSCP is not overwritten, and the value is assigned a
4
forwarding queue.
Assigning DSCP Values Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the
DSCP Mapping page.
contains the following fields:
C o n f i g u r i n g Q u a l i t y o f S e r vi c e
349