Dell PowerConnect 3324 User Manual page 278

Configuring LACP Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring LACP
parameters as displayed in the Link Aggregation page.
CLI Command
lacp system-priority value
lacp port-priority value
lacp timeout {long | short}
show lacp ethernet
interface [parameters |
statistics | protocol-state]
show lacp port-channel
[port_channel_number]
The following is an example of the CLI commands:
Console (config)# lacp system-priority 120
Console (config)# interface ethernet 1/e8
Console (config-if)# lacp port-priority 247
Console (config-if)# lacp timeout long
Console (config-if)# exit
Console# show lacp ethernet 1/e1 statistics
Port 1/e1 LACP Statistics:
LACP PDUs sent:2
LACP PDUs received:2
278 Configuring Switch Infor m ation
Description
Configures the system priority.
Configures the priority value for physical
ports.
Assigns an administrative LACP
timeout.
Displays LACP information for ethernet
ports.
Displays LACP information for a Port-
channel.