Dell PowerConnect 3324 User Manual page 232

Removing a static address from the Static Address Table:
Open the Static Address Table.
1
Click Show All to open the Static MAC Address Table.
2
Select a single or multiple table entries.
3
Check the Remove check box.
4
Click Apply Changes. The selected static addresses are deleted, and the device is
5
updated.
Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static
address parameters as displayed in the Add Static MAC Address page.
CLI Command
bridge address mac-address
{ethernet interface | port-
channel port-channel-
number} [permanent | delete-
on-reset | delete-on-timeout|
secure]
show bridge address-table static
[vlan vlan] [ethernet
interface | port-channel
port-channel-number]
The following is an example of the CLI commands:
Console (config-vlan)# bridge address 168.210.0.10 ethernet 1/e8
permanent
Console# show bridge address table static
Aging time is 300 sec
vlan
---- -------------- ----- -----
200 0010.0D48.37FF 5/9 delete-on-reset
232 Configuring Switch Infor m ation
mac address port type
Description
Adds a static MAC-layer station source
address to the bridge table.
Displays classes of statically entered
entries in the bridge-forwarding
database.