Displaying the Port Parameters Table:
Open the Storm Control page .
1
Click Show All. The Storm Control Settings Table opens.
2
S t o r m C o n t r o l S e t t i n g s Ta b l e
Configuring Storm Control with CLI Commands
The following table summarizes the equivalent CLI commands for configuring storm
control as displayed in the Storm Control page.
CLI Command
port storm-control enable
{unknown | broadcast |
multicast} {fastethernet |
gigaethernet interface}
port storm-control rate
gigaethernet interface
rate.
show ports storm-control
The following is an example of the CLI commands:
Console(config)# port storm-control rate fastethernet 300
Console(config)# port storm-control enable fastethernet
Console# show ports storm-control
PortUnknownBroadcastMulticastRate
224
Configuring Switch Infor m ation
Description
Enables broadcast storm control for
Unicast, Multicast, and Broadcast packets.
Configures the maximum broadcast rate.
Displays the storm control configuration.