Dell PowerConnect 3324 User Manual page 213

P o r t s C o n f i g u r a t i o n Ta b l e
In addition to the Port Configuration page fields, the Port Configuration Table also
displays the following field:
• Unit Number—Indicates the stacking unit number for which the port information is
displayed.
Configuring Ports with CLI Commands
The following examples describe how to set a port to MDIX or MDI mode. To set a port to
MDIX mode, enter the following at the system prompt:
console(config-if)# mdix on
The following message displays:
console # show inter config ethernet 1/e1
Port Type
.......................................................
1/e1 100M-Copper
To set a port to MDI mode, enter the following at the system prompt:
console(config)# inter eth 1/e1
console(config-if)# no mdix
The following message displays:
console # show inter config ethernet 1/e1
Port Type
.......................................................
1/e1 100M-Copper
Duplex Speed Neg
Enabled Off
Duplex Speed Neg
Enabled Off
Flow Admin Back
Control State Pressure Mode
Up Disabled On
Flow Admin Back
Control State Pressure Mode
Up Disabled Off
Configuring Switch Infor mation
Mdix
Mdix
213