Dell PowerConnect 3324 User Manual page 283

• IGMP Snooping Status—Indicates if IGMP snooping is enabled on the device. The
possible field values are:
– Enabled—Enables IGMP snooping on the specific VLAN.
– Disabled—Disables IGMP snooping on the specific VLAN. This is the default
value.
Enabling bridge multicast filtering on the device:
Open the Multicast Global Parameters page.
1
Select Enable in the bridge multicast filtering field.
2
Click Apply Changes. Bridge Multicast is enabled on the device.
3
Enabling IGMP snooping on the device:
Open the Multicast Global Parameters page.
1
Select Enable in the IGMP Snooping Status field.
2
Click Apply Changes. IGMP snooping is enabled on the device.
3
Enabling Multicast Forwarding and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling multicast
forwarding and IGM snooping as displayed in the Multicast Support page.
CLI Command
bridge multicast filtering
ip igmp snooping
The following is an example of the CLI commands:
Console (config)# bridge multicast filtering
Console (config)# ip igmp snooping
Description
Enables filtering of multicast addresses.
Enables Internet Group Management
Protocol (IGMP) snooping.
Configuring Switch Infor mation
283