Figure 25-11 Menu 11.4 Remote Node Setup Script; Table 25-8 Menu 11.4 Remote Node Setup Script - ZyXEL Communications PRESTIGE 653HX User Manual

'Expect' and the 'Send' fields of the current set are empty, the Prestige will terminate the script processing
and start PPP negotiation. This implies two things: first, the sets must be contiguous; the sets after an empty
one are ignored. Second, the last set should match the final message sent by the server. For instance, if the
server prints:
login successful.
Starting PPP...
After you enter the password, then you should create a third set to match the final "PPP..." but without a
"Send" string. Otherwise, the Prestige will start PPP prematurely right after sending your password to the
server.
If there are errors in the script and it gets stuck at a set for longer than the "Dial Timeout" in menu 2
(default 60 seconds), the Prestige will timeout and drop the line. To debug a script, go to Menu 24.4 to
initiate a manual call and watch the trace display to see if the sequence of messages and prompts from the
server differs from what you expect.
The following table describes the fields in this menu.
FIELD
Active Press [SPACE BAR] and then [ENTER] to select either Yes to enable
the AT strings or No to disable them.
Menu 2 WAN Backup Setup
Menu 11.4 - Remote Node Script
Active= No
Set 1:
Expect=
Send=
Set 2:
Expect=
Send=
Set 3:
Expect=
Send=
Set 4:
Expect=
Send=
Enter here to CONFIRM or ESC to CANCEL:

Figure 25-11 Menu 11.4 Remote Node Setup Script

Table 25-8 Menu 11.4 Remote Node Setup Script

Set 5:
Expect=
Send=
Set 6:
Expect=
Send=
DESCRIPTION
Prestige 653HWI Series User's Guide
EXAMPLE
No
(default)
25-17