Prestige 653HWI Series User's Guide
Base Trans
Rate(Kbps)
Max Trans
Rate(Kbps)
Target
Utility(Kbps)
25.9 Editing TCP/IP Options
Move the cursor to the Edit IP field in Menu 11.1 - Remote Node Profile (Backup ISP), then press
[SPACE BAR] to select Yes. Press [ENTER] to open Menu 11.3 - Network Layer Options.
IP Options:
Figure 25-10 Menu 11.3 Remote Node Network Layer Options
The following table describes the fields in this menu.
25-14
Table 25-6 Menu 11.2 Remote Node PPP Options
Select the base data transfer rate for this remote node in kilobits
per second. There are two choices for this field: 64 where only
one channel is used or, 128 where two channels are used as
soon as a packet triggers a call.
Enter the maximum data transfer rate allowed for this remote
node. This parameter is in kilobits per second.
Enter the two thresholds separated by a [–] for subtracting and
adding the second port.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= Full Feature
Address Mapping Set= 1
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL:
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Menu 2 WAN Backup Setup
64
64
Default = 32–48