Figure 31-3 Menu 12.3.1 Edit Bridge Static Route; Table 31-1 Remote Node Network Layer Options : Bridge Fields; Table 31-2 Menu 12.3.1 Edit Bridge Static Route - ZyXEL Communications PRESTIGE 653HX User Manual

Table 31-1 Remote Node Network Layer Options : Bridge Fields

FIELD
Bridge (menu 11.1)
Edit IP/Bridge (menu
11.1)
Ethernet Addr Timeout
(min.) (menu 11.3)
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
31.2.2 Bridge Static Route Setup
Similar to network layer static routes, a bridging static route tells the Prestige the route to a node before a
connection is established. You configure bridge static routes in menu 12.3.1 (go to menu 12, choose option
3, then choose a static route to edit) as shown next.
The following table describes the Edit Bridge Static Route menu.
FIELD
Route # This is the route index number you typed in Menu 12.3 – Bridge Static Route Setup.
Route Name Type a name for the bridge static route for identification purposes.
Bridging Setup
Make sure this field is set to Yes.
Press [SPACE BAR] to select Yes and press [ENTER] to display menu 11.3.
Type the time (in minutes) for the Prestige to retain the Ethernet Address
information in its internal tables while the line is down. If this information is
retained, your Prestige will not have to recompile the tables when the line
comes back up.
Menu 12.3.1 - Edit Bridge Static Route
Route #: 1
Route Name=
Active= No
Ether Address= ?
IP Address=
Gateway Node= 1
Press ENTER to Confirm or ESC to Cancel:

Figure 31-3 Menu 12.3.1 Edit Bridge Static Route

Table 31-2 Menu 12.3.1 Edit Bridge Static Route

Prestige 653HWI Series User's Guide
DESCRIPTION
DESCRIPTION
31-3