Table of Contents
Advertisement
Prestige 653HWI Series User's Guide
Calling Line Indication= Enable
PABX Outside Line Prefix=
PABX Number (Include S/T Bus Number) for Loopback=
Outgoing Calling Party Number:
ISDN Data
Data Link Connection= point-to-multipoint
When you are finished, press [ENTER] at the message: 'Press ENTER to confirm', the router uses the
information that you entered to initialize the ISDN line. It should be noted that whenever the switch type is
changed, the ISDN initialization takes slightly longer.
At this point, the router asks if you wish to test your ISDN. If you select Yes, the router will perform a
loop-back test to check the ISDN line. If the loop-back test fails, please note the error message that you
receive and take the appropriate troubleshooting action.
Setup LoopBack Test ...
Dialing to 40000// ...
Sending and Receiving Data ...
Disconnecting ...
LoopBack Test OK
### Hit any key to continue. ###
25.6 NetCAPI Setup Menu
Select Yes in the Edit NetCAPI Setup field of Menu 2 – Menu 2 WAN Backup Setup to display Menu
2.2.2 as below.
25-8
Menu 2.2.1 - ISDN Advanced Setup
= 80010029
Press ENTER to Confirm or ESC to Cancel:
Figure 25-5 Menu 2 ISDN Setup for DSS1
Figure 25-6 Loopback Test
Menu 2 WAN Backup Setup
Advertisement
Table of Contents
