ZyXEL Communications PRESTIGE 653HX User Manual page 255

LABEL
BW Budget (kbps)
Priority
Borrow bandwidth
from parent class
Bandwidth Filter
The Prestige uses a bandwidth filter to identify the traffic that belongs to a bandwidth class.
Active
Service
Destination IP
Address
Destination Subnet
Mask
Destination Port
Bandwidth Management
Table 21-4 Bandwidth Manager: Class Configuration
Specify the maximum bandwidth allowed for the class in kbps. The
recommendation is a setting between 20 kbps and 20000 kbps for an individual
class.
Enter a number between 0 and 7 to set the priority of this class. The higher the
number, the higher the priority. The default setting is 3.
Select this option to allow a child-class to borrow bandwidth from its parent class if
the parent class is not using up its bandwidth budget.
Bandwidth borrowing is governed by the priority of the child-classes. That is, a
child-class with the highest priority (7) is the first to borrow bandwidth from its
parent class.
Do not select this for the classes directly below the root class if you want to leave
bandwidth available for other traffic types (see 21.6.1) or you want to set the
interface's speed to match what the next device in network can handle (see the
Speed field description in Table 21-2).
Select the check box to have the Prestige use this bandwidth filter when it
performs bandwidth management.
You can select a predefined service instead of configuring the Destination Port,
Source Port and Protocol ID fields.
SIP (Session Initiation Protocol) is a signaling protocol used in Internet telephony,
instant messaging and other VoIP (Voice over IP) applications. Select SIP from the
drop-down list box to configure this bandwidth filter for traffic that uses SIP. At the
time of writing, SIP was the only predefined service.
When you select None, the bandwidth class applies to all services unless you
specify one by configuring the Destination Port, Source Port and Protocol ID
fields.
Enter the destination IP address in dotted decimal notation. A blank destination IP
address means any destination IP address.
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination IP Address. Refer to the appendix for more information on IP
subnetting.
Enter the port number of the destination. A blank destination port means any
destination port.
Prestige 653HWI Series User's Guide
DESCRIPTION
21-15