Choosing a Patch
Basic Procedure for Choosing a Patch
fig.0-05.e
On the PATCH PLAY screen, turn [VALUE] to choose the desired Patch.
As you turn [VALUE], press the [VALUE] knob to change values in large steps. You
can also hold down [SHIFT] as you turn to change values in large steps.
Choosing a Bank
fig.0-06
Press [
BANK]/[BANK
• Pressing [BANK
US (User) -> PA (Preset A) -> PB (Preset B) -> . . . -> GM (General MIDI)-> XA
(Expansion A) -> XB (Expansion B)
• Pressing [
BANK] changes the Bank as below.
XB (Expansion B)-> XA (Expansion A)-> GM (General MIDI) -> PH (Preset H) -> PG
(Preset G) -> . . . -> US (User)
Choosing a Patch by Category (Patch Finder)
The XV-5050's "Patch Finder" allows you to quickly find any Patch.
fig.0-07
1.
Press [PATCH] to make its indicator light.
2.
Press [PATCH FINDER] to make its indicator light.
The current category appears in the upper right of the display.
fig.0-08
3.
Press [
CURSOR]/[CURSOR
] in Patch mode to select a new Bank.
] changes the Bank as shown below.
2, 5
4
] to select the desired category.
1
3
Playing Sounds
You cannot select XA or XP
unless a Wave Expansion
Board is installed into the
corresponding slot.
21