Rear Panel - Roland XV-5050 Owner's Manual

Panel Descriptions

Rear Panel

fig.FrontPanel
K
K
AC Inlet
Connect the included power cable here. (p. 13)
L
MIDI Connectors (IN, OUT, THRU)
These connectors connect the XV-5050 with other MIDI devices,
enabling the sending and receiving of MIDI messages. (p. 19)
IN: This connector receives messages from another MIDI device.
Out: This connector transmits messages to another MIDI device.
Thru: MIDI messages received at the MIDI IN connector will be
retransmitted from this connector without being changed by
the XV-5050.
M
Digital Out Connectors
The XV-5050 features both optical and coaxial digital out connectors
(conforming to S/P DIF).
S/P DIF: A digital interface format used for consumer digital audio
devices.
12
L M
N
A (MIX) OUTPUT Jacks (L (MONO), R)
These jacks send audio signals in stereo (L/R) from the XV-5050 to
an amp or mixer. For a mono output, use only the L jack. (p. 13)
These jacks are used when the SYSTEM SETUP Mix/Parallel
parameter is set to MIX. (p. 107)
* The XV-5050, as shipped from the factory, routes the output of all
PRESET Patches to these jacks.
O
B OUTPUT Jacks (L, R)
These jacks send audio signals in stereo (L/R) from the XV-5050 to
an amp or mixer. (p. 13)
P
INDIVIDUAL 1–6 OUTPUT Jacks
These jacks output audio signals in mono from the XV-5050 to an
amp or mixer. (p. 13)
O N
P