Windows 98 / Me Users - Roland XV-5050 Owner's Manual

Windows 98 / Me Users

Use the following procedure to install the XV-5050 Driver.
* Disconnect the XV-5050 from your computer before starting up Windows.
1.
With all USB cables disconnected, start up Windows. (except the
keyboard and mouse)
2.
Exit all applications before you begin installing the driver.
3.
Insert the XV-5050 Driver CD-ROM into the CD-ROM drive.
4.
From the Windows Start menu, select "Run."
5.
In the "Open" field of the dialog box that
appears, enter "D:\Win98\Setupinf.exe"
and click "OK."
* Enter the drive name D: appropriate for the drive name of your CD-ROM drive.
6.
The SETUPINF dialog box appears, and
the display indicates "Ready to install the
driver.---"
* Don't click "OK" here.
Installing & Setup the Driver
If the XV-5050 is already
connected to your computer
and a message of "Add New
Hardware Wizard" is
displayed, go to the XV-5050
Driver CD-ROM folder
named Win98, open the file
README_E.HTM, and read
the "Troubleshooting"
section entitled "You
attempted to install using
the above procedure, but
were not able to."
If you wish to use the XV-
5050 at the same time as
another USB device
connected to your computer,
disconnect the other USB
device from the USB
connector before installing
the XV-5050 driver. If another
USB device is connected to
your computer when you
install the XV-5050 driver, the
XV-5050 driver may not be
installed correctly.
The "Win98\Setupinf.exe"
file cannot be used on
Windows 2000.
To check the drive name of
your CD-ROM drive,
double-click the My
Computer icon.
If the "Ready to install the
driver.---" dialog box does
not appear, go to the XV-
5050 Driver CD-ROM
folder named Win98, open
the README_E.HTM file,
and read the section
entitled "Installation."
125