Windows 2000 Users - Roland XV-5050 Owner's Manual

Installing & Setup the Driver

Windows 2000 Users

Use the following procedure to install the XV-5050 driver.
* Disconnect the XV-5050 from your computer before starting up Windows.
* To install the driver, you must log on to Windows as the Administrator or other user with
the privileges of the Administrators group. For more information regarding this, consult
your computer system administrator.
1.
With all USB cables disconnected, start up Windows. (except the
keyboard and mouse)
2.
Log onto Windows as an Administrator, or other user that is a
member of the Administrators group.
3.
Exit all applications before performing the installation.
4.
Make "Driver Signing" settings.
Open the "Control Panel," and double-click
"System."
Click the "Hardware" tab, and then click the "Driver
Signing" button. The "Driver Signing Options"
dialog box appears.
5.
Make sure that "File signature verification"
is set to "Ignore."
If it is set to "Ignore," click "OK." If not, make a note
of the current setting; then change it to "Ignore" and
click the "OK" button.
6.
Click the "OK" button to close "System Properties."
7.
Insert the XV-5050 Driver CD-ROM into the CD-ROM drive.
8.
From the Windows Start menu, select "Run."
128
If the XV-5050 is already
connected to your computer
and a message of "Found
New Hardware Wizard" is
displayed, go to the XV-5050
Driver CD-ROM folder
named Win2000, open the
file README_E.HTM, and
read the "Troubleshooting"
section entitled "You
attempted to install using
the above procedure, but
were not able to."