Installing & Setup the Driver
Using OMS on the Macintosh
Installing the XV-5050 Driver
Use the following procedure to install the XV-5050 driver.
* Disconnect the XV-5050 from your Macintosh before installing the driver.
* Exit all applications before you begin installing the driver.
* The XV-5050 OMS Driver included on the disc is provided as an additional module that
allows the XV-5050 to be used with OMS. In order to use it, OMS must already be installed
on the start-up hard disk.
1.
In the "XV Driver E" folder of the CD-ROM, double-click the
"OMS-E" icon.
2.
Make sure that OMS is already installed in the
location where the driver will be installed, and
click [Install].
3.
If the following message appears, click
[Continue] and all other currently-running
applications will be exited, and installation will
continue.
4.
When installation is completed, the
following dialog box appears. Click
[Restart] to restart your Macintosh.
OMS settings
1.
Use the USB cable to connect the XV-5050 and your Macintosh.
fig.USB-01
USB connector
of your computer
Computer
2.
Double-click the "OMS Setup" icon.
132
USB cable
You can download OMS
from the Web site of
Opcode System, Inc.
About detailed information
for OMS, refer to the
Owner's Manual of OMS.
To prevent malfunction
and/or damage to speakers
or other devices, always
XV-5050
turn down the volume, and
turn off the power on all
devices before making any
connections.
If you are using the XV-
5050 with a sequencer, do
not disconnect the MIDI
cable connected to the XV-
5050 while a song is
playing back.