Installing The Wave Expansion Board; Cautions When Installing An Wave Expansion Board; How To Install A Wave Expansion Board - Roland XV-5050 Owner's Manual

Installing the Wave Expansion Board

The XV-5050 can be further expanded with the installation of up to
two optional wave expansion boards (SRX Series). Wave data is
stored in these wave expansion boards. Also stored are Patches and
Rhythm Sets that use the Wave data from the wave expansion
boards, allowing these to be called up directly for use.
Cautions When Installing an
Wave Expansion Board
901
● To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the following
whenever you handle the board.
1
• Before you touch the board, always first grasp a metal object
(such as a water pipe), so you are sure that any static
electricity you might have been carrying has been discharged.
2
• When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
5
• Save the bag in which the board was originally shipped, and
put the board back into it whenever you need to store or
transport it.
● Use a Philips screwdriver that is suitable for the size of the screw
(a number 2 screwdriver). If an unsuitable screwdriver is used,
the head of the screw may be stripped.
● To remove a screw, rotate the screwdriver counter-clockwise. To
tighten a screw, rotate the screwdriver clockwise.
fig.Screw.e
loosen
● When installing Wave Expansion Boards, remove only the
specified screws.
● Be careful that the screws you remove do not drop into the
interior of the XV-5050.
● Do not leave the cover in a detached state. Be sure to reattach it
after the Wave Expansion Boards have been installed.
911
● Do not touch any of the printed circuit pathways or connection
terminals.
● Be careful not to cut your hand on the edge of the installation bay.
912
● Never use excessive force when installing a circuit board. If it
doesn't fit properly on the first attempt, remove the board and try
again.
913
● When circuit board installation is complete, double-check your
work.
914
● Always turn the unit off and unplug the power cord before
attempting installation of the circuit board (SRX series; p. 14).
915
● Install only the specified circuit board(s) (SRX series). Remove
only the specified screws (p. 120).
120
tighten
How to Install a Wave
Expansion Board
1. Before installing the wave expansion board, turn off the
power to the XV-5050 and to any device connected to the
XV-5050.
2. Remove only the top panel screws specified in the following
figure.
fig.Install1
3. Remove the cover.
4. Orient the board holder as shown in the figure.
fig.Install2.e
Holder
5. Slots are provided inside the XV-5050 for SRX Series
boards. Referring to the diagram below, plug the wave
expansion board's connector into the connector in the wave
expansion board slot, and simultaneously insert the board
holder into the hole in the Wave expansion board.
fig.Install3.e
6. Use the locking hardware included with the wave expansion
board to rotate the board holder to the LOCK position and
fasten the wave expansion board.
fig.Install4
7. Using the screws removed in Step 2, refasten the cover in its
original position.
This completes the installation of the wave expansion board.
Connector
Holder
LOCK