Ricoh Aficio 1022 Operating Instructions Manual page 773

Using a Program
Note
❒ When using a program, the set-
tings that you have already made
are canceled.
Example of executing a program
using Send Later with the fax
number "0123456789".
A A A A
Make sure that the machine is in
Facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not
shown, press the { { { { Facsimile} } } }
key.
B B B B
Place your original.
Note
❒ If you have not registered desti-
nations or scan settings as a pro-
gram, enter the fax number for
the destination and select any
scan settings you require.
C C C C
Press the { { { { Program} } } } key.
D D D D
Select a program number you reg-
istered.
The initial display is shown.
Then, the registered fax number
and time are shown. Transmission
Mode is selected.
Note
❒ If the number of the program to
be used is not shown, press [U U U U
Prev.] or [T T T T Next].
E E E E
Press the { { { { Start} } } } key.
The fax number and specified time
are shown on the display and the
machine starts to scan the original.
Changing a Program Name
You can only change a program
name.
Limitation
❒ When a registered program is be-
ing used for a standby Memory
Transmission, you cannot change
the program name.
A A A A
Make sure that the machine is in
Facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not
shown, press the { { { { Facsimile} } } }
key.
B B B B
Press the { { { { Program} } } } key.
C C C C
Press [Change Name].
Programs
6
99