Ricoh Aficio 1022 Operating Instructions Manual page 450

Troubleshooting
Messages/Second messages
Following output tray is full.
Remove the paper. Internal
Tray 1.
Following output tray is full.
Remove the paper. Internal
Tray 2.
HDD has a problem. Call ser-
vice representative.
HDD has not been installed.
HDD is full.
4
HDD is full.
Hex Dump Mode
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
Invalid Password Try Again. An invalid password has been entered for a locked print job.
Load following paper in #, or
select another tray and press
[Continue]. To cancel job,
press [Reset].
Menu Protected Cannot
Change.
No Files Exist.
NV-RAM has a problem. Call
service representative.
Offline
Output tray has been
changed.
Overflow
Paper in duplex unit. Open
cover and remove paper.
Paper in staple tray. Open
finisher cover and remove
paper.
38
Descriptions and Solutions
Internal Tray 1 is full. Remove paper from the tray.
Internal Tray 2 is full. Remove paper from the tray.
An error has occurred in the optional Hard Disk Drive.
First turn the power switch off and then on. If the message ap-
pears again, call your sales or service representative.
Install an HDD unit. If this error reappears even if there is an
HDD unit installed, contact your service representative.
Delete unnecessary files stored in the machine. Also, reduce the
size of sample or locked print files.
Delete unnecessary fonts or forms stored in the machine.
The machine is in Hex Dump Mode.Wait for a while, and if the
"Hex Dump Mode" message does not disappear, press { { { { Online} } } }
on the Display panel to return to the "Ready" condition.
The LCT is malfunctioning. Turn the main power off on the ma-
chine and after 5 seconds turn the power on again. If the same
message appears again, contact your service representative.
The specified paper tray is empty. Set paper in the paper tray
or press [Form Feed], specify another paper tray, and then press
[Continue] or [Reset].
The selected menu is protected.
The sample print or locked print file is not found.
An error has occurred in the optional Memory Unit.
Turn off the power switch, replace the Memory Unit, and then
turn on the power switch.
The machine is offline.
If you want to put the machine online, press [Online].
Set the correct output tray.
Display list overflow occurred during printing with PCL or PS3.
Expand memory.
There is a misfeed in the Duplex Unit.
Remove the misfed paper.
Remove the paper remaining inside the finisher.