Dynamic Configuration - Enterasys Matrix-V V2H124-24 Configuration Manual

Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#

Dynamic Configuration

If you select the "bootp" or "dhcp" option, IP will be enabled but will not function until
a BOOTP or DHCP reply has been received. You therefore need to use the "ip dhcp
restart" command to start broadcasting service requests. Requests will be sent
periodically in an effort to obtain IP configuration information. (BOOTP and DHCP
values can include the IP address, subnet mask, and default gateway.)
If the "bootp" or "dhcp" option is saved to the startup-config file, then the switch will
start broadcasting service requests as soon as it is powered on.
To automatically configure the switch by communicating with BOOTP or DHCP
address allocation servers on the network, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt, type
"interface vlan 1" to access the interface-configuration mode. Press <Enter>.
2. At the interface-configuration mode prompt, use one of the following
commands:
• To obtain IP settings through DHCP, type "ip address dhcp" and press
<Enter>.
• To obtain IP settings through BOOTP, type "ip address bootp" and press
<Enter>.
3. Type "exit" to return to the global configuration mode. Press <Enter>.
4. Type "ip dhcp restart" to begin broadcasting service requests. Press <Enter>.
5. Wait a few minutes, and then check the IP configuration settings by typing the
"show ip interface" command. Press <Enter>.
6. Then save your configuration changes by typing "copy running-config
startup-config." Enter the startup file name and press <Enter>.
Basic Configuration
2-7
2