Spanning-Tree Pathcost Method; Spanning-Tree Transmission-Limit - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface
Example
Console(config)#spanning-tree default priority 802.1D-1998
Console(config)#

spanning-tree pathcost method

Use this command to configure the path cost method used for Rapid Spanning Tree.
Use the no form to restore the default.
Syntax
spanning-tree pathcost method {long | short}
no spanning-tree pathcost method
• long - Specifies 32-bit based values that range from 1-200,000,000.
• short - Specifies 16-bit based values that range from 1-65535.
Default Setting
Long method
Command Mode
Global Configuration
Command Usage
The path cost method is used to determine the best path between devices.
Therefore, lower values should be assigned to ports attached to faster media,
and higher values assigned to ports with slower media. Note that path cost
(page 4-184) takes precedence over port priority (page 4-190).
Example
Console (config)# spanning-tree pathcost method long
Console (config)#

spanning-tree transmission-limit

Use this command to configure the minimum interval between the transmission of
consecutive RSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count -The transmission limit in seconds. (Range: 1-10)
Default
3
Command Mode
Global Configuration
4-184