Show Mac Access-Group; Map Access-List Mac; Table 4-41. Mapping Cos Values To Mac Acl Rules - Enterasys Matrix-V V2H124-24 Configuration Manual

Related Commands
show mac access-list (4-128)

show mac access-group

This command shows the ports assigned to MAC ACLs.
Command Mode
Privileged Exec
Example
Console#show mac access-group
Interface ethernet 1/5
MAC access-list M5 out
Console#
Related Commands
mac access-group (4-132)

map access-list mac

This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output queue; it
is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list mac acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to the
rule.
• A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown below.
Queue
Priority

Table 4-41. Mapping CoS Values to MAC ACL Rules

0 1
1,2 3
Access Control List Commands
2
4,5
4
3
6,7
4-133