Show Marking - Enterasys Matrix-V V2H124-24 Configuration Manual

Command Usage
• You must configure an ACL mask before you can change frame priorities
based on an ACL rule.
• Traffic priorities may be included in the IEEE 802.1p priority tag. This tag is
also incorporated as part of the overall IEEE 802.1Q VLAN tag. To specify
this priority, use the set priority keywords.
• The IP frame header also includes priority bits in the Type of Service (ToS)
octet. The Type of Service octet may contain three bits for IP Precedence or
six bits for Differentiated Services Code Point (DSCP) service. To specify the
IP precedence priority, use the set tos keywords. To specify the DSCP
priority, use the set dscp keywords. Note that the IP frame header can
include either the IP Precedence or DSCP priority type.
• The precedence for priority mapping by this switch is IP Precedence or
DSCP Priority, and then 802.1p priority.
Example
Console(config)#interface ethernet 1/12
Console(config-if)#match access-list ip bill set dscp 0
Console(config-if)#
Related Commands

show marking (4-125)

show marking
This command displays the current configuration for packet marking.
Command Mode
Privileged Exec
Example
Console#show marking
Interface ethernet 1/12
match access-list IP bill set DSCP 0
match access-list MAC a set priority 0
Console#
Related Commands
match access-list ip (4-124)
Access Control List Commands
4
4-125