Configuring Static Dns Host To Address Entries - Enterasys Matrix-V V2H124-24 Configuration Manual

3
Configuring the Switch
CLI - This example sets a default domain name and a domain list. However,
remember that if a domain list is specified, the default domain name is not used.
Console(config)#ip domain-name sample.com
Console(config)#ip domain-list sample.com.uk
Console(config)#ip domain-list sample.com.jp
Console(config)#ip name-server 192.168.1.55 10.1.0.55
Console(config)#ip domain-lookup
Console#show dns
Domain Lookup Status:
DNS enabled
Default Domain Name:
.sample.com
Domain Name List:
.sample.com.uk
.sample.com.jp
Name Server List:
192.168.1.55
10.1.0.55
Console#

Configuring Static DNS Host to Address Entries

You can manually configure static entries in the DNS table that are used to map
domain names to IP addresses.
Command Usage
• Static entries may be used for local devices connected directly to the attached
network, or for commonly used resources located elsewhere on the network.
• Servers or other network devices may support one or more connections via
multiple IP addresses. If more than one IP address is associated with a host name
in the static table or via information returned from a name server, a DNS client can
try each address in succession, until it establishes a connection with the target
device.
Field Attributes
• Host Name – Name of a host device that is mapped to one or more IP addresses.
(Range: 1-64 characters)
• IP Address – Internet address(es) associated with a host name.
(Range: 1-8 addresses)
• Alias – Displays the host names that are mapped to the same address(es) as a
previously configured entry.
3-180
4-240
4-241
4-242
4-243
4-244