Dns Commands; Table 4-74. Dns Commands - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface
Example
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#

DNS Commands

These commands are used to configure Domain Naming System (DNS) services.
You can manually configure entries in the DNS domain name to IP address mapping
table, configure default domain names, or specify one or more name servers to use
for domain name to address translation.
Note that domain name services will not be enabled until at least one name server is
specified with the ip name-server command and domain lookup is enabled with the
ip domain-lookup command. This switch can be configured to relay DHCP client
configuration requests to a DHCP server on another network, or you can configure
this switch to provide DHCP service directly to any client.
Command
ip host
clear host
ip domain-name
ip domain-list
ip name-server
ip domain-lookup
show hosts
show dns
show dns cache
clear dns cache
4-238

Table 4-74. DNS Commands

Function
Creates a static host name-to-address mapping
Deletes entries from the host name-to-address table
Defines a default domain name for incomplete host names
Defines a list of default domain names for incomplete host names GC
Specifies the address of one or more name servers to use for host
name-to-address translation
Enables DNS-based host name-to-address translation
Displays the static host name-to-address mapping table
Displays the configuration for DNS services
Displays entries in the DNS cache
Clears all entries from the DNS cache
Mode Page
GC 4-239
PE 4-239
GC 4-240
4-241
GC 4-242
GC 4-243
PE 4-244
PE 4-244
PE 4-245
PE 4-245