Priority Commands (Layer 3 And 4); Map Ip Port (Global Configuration); Table 4-67. Priority Commands (Layer 3 And 4) - Enterasys Matrix-V V2H124-24 Configuration Manual

Priority Commands (Layer 3 and 4)

Command
map ip port
map ip port
map ip precedence
map ip precedence
map ip dscp
map ip dscp
map access-list ip
map access-list mac
show map ip port
show map ip precedence Shows the IP precedence map
show map ip dscp
show map access-list ip
show map access-list mac Shows CoS value mapped to an access list for an interface

map ip port (Global Configuration)

Use this command to enable IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping globally:
Console(config)#map ip port
Console(config)#

Table 4-67. Priority Commands (Layer 3 and 4)

Function
Enables TCP class of service mapping
Maps TCP socket to a class of service
Enables IP precedence class of service mapping
Maps IP precedence value to a class of service
Enables IP DSCP class of service mapping
Maps IP DSCP value to a class of service
Sets the CoS value and corresponding output queue for
packets matching an ACL rule
Sets the CoS value and corresponding output queue for
packets matching an ACL rule
Shows the IP port map
Shows the IP DSCP map
Shows CoS value mapped to an access list for an interface
4
Priority Commands
Mode Page
GC 4-217
IC 4-218
GC 4-218
IC 4-219
GC 4-220
IC 4-220
IC 4-123
IC 4-133
PE 4-221
PE 4-222
PE 4-223
PE 4-124
PE 4-134
4-217