Setting Passwords - Enterasys Matrix-V V2H124-24 Configuration Manual

Access to both CLI levels are controlled by user names and passwords. The switch
has a default user name and password for each level. To log into the CLI at the
Privileged Exec level using the default user name and password, perform these
steps:
1. To initiate your console connection, press <Enter>. The "User Access
Verification" procedure starts.
2. At the Username prompt, enter "admin."
3. At the Password prompt, also enter "admin." (The password characters are not
displayed on the console screen.)
4. The session is opened and the CLI displays the "Console#" prompt indicating
you have access at the Privileged Exec level.

Setting Passwords

Note: If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the "username" command, record
them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case sensitive.
To prevent unauthorized access to the switch, set the passwords as follows:
1. Open the console interface with the default user name and password "admin" to
access the Privileged Exec level.
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec level, where
password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec level,
where password is your new password. Press <Enter>.
Username: admin
Password:
CLI session with the Intelligent Switch is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
Basic Configuration
2-5
2