Radius Client; Table 4-31. Radius Client Commands - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface
• You can specify three authentication methods in a single command to
indicate the authentication sequence. For example, if you enter
"authentication enable radius tacacs local," the user name and password
on the RADIUS server is verified first. If the RADIUS server is not available,
then authentication is attempted on the TACACS+ server. If the TACACS+
server is not available, the local user name and password is checked.
Example
Console(config)#authentication enable radius
Console(config)#
Related Commands
enable password (4-27)

RADIUS Client

Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
RADIUS-aware devices on the network. An authentication server contains a
database of multiple user name/password pairs with associated privilege levels for
each user or group that require management access to a switch.
Command
radius-server host
radius-server port
radius-server key
radius-server retransmit
radius-server timeout
radius-server service-type
show radius-server
4-86

Table 4-31. RADIUS Client Commands

Function
Specifies the RADIUS server
Sets the RADIUS server network port
Sets the RADIUS encryption key
Sets the number of retries
Sets the interval between sending authentication requests GC
Sends the Filter ID to the RADIUS server during
authentication
Shows the current RADIUS settings
Mode Page
GC 4-87
GC 4-88
GC 4-88
GC 4-89
4-89
GC 4-90
PE 4-92