Layer 2 Igmp Configuration Commands; Layer 3 Igmp Configuration Commands - Enterasys C5G124-24 Configuration Manual

Configuring IGMP
Table 19-3 Layer 2 IGMP Configuration Commands
Task
Enable or disable IGMP on the system.
Enable or disable IGMP on one or all ports.
Configure the IGMP group membership interval time
for the system.
Configure the IGMP query maximum response time
for the system.
Configure the IGMP multicast router expiration time
for the system.
Create a new static IGMP entry or add one or more
new ports to an existing entry.
Delete a static IGMP entry or remove one or more
new ports from an existing entry.
Clear all IGMP snooping entries.
Table 19-4
basic routing.
Table 19-4 Layer 3 IGMP Configuration Commands
Task
Enable IGMP on the router. Use the no command to
disable IGMP on the router.
Enable IGMP on an interface. Use the no command
to disable IGMP on an interface.
Set the version of IGMP running on the router. Use
the no command to reset IGMP to the default
version of 2 (IGMPv2).
Set the IGMP query interval on a routing interface.
Use the no command to reset the IGMP query
interval to the default value of 125 seconds.
Set the maximum response time interval advertised
in IGMPv2 queries. Use the no command to reset
the IGMP maximum response time to the default
value of 100 (one tenth of a second).
Set the interval between general IGMP queries sent
on startup. Use the no command to reset the IGMP
startup query interval to the default value of 31
seconds.
Set the number of IGMP queries sent out on startup,
separated by the startup-query-interval. Use the
no command to reset the IGMP startup query count
to the default value of 2.
19-16 Configuring Multicast
lists the Layer 3 IGMP configuration commands for fixed switch devices that support
Command
set igmpsnooping adminmode {enable | disable}
set igmpsnooping interfacemode port-string
{enable | disable}
set igmpsnooping groupmembershipinterval
time
set igmpsnooping maxresponse time
set igmpsnooping mcrtrexpire time
set igmpsnooping add-static group vlan-list
[modify] [port-string]
set igmpsnooping remove-static group vlan-list
[modify] [port-string]
clear igmpsnooping
Command
ip igmp
no ip igmp
ip igmp enable
no ip igmp enable
ip igmp version version
no ip igmp
ip igmp query-interval time
no ip igmp query-interval
ip igmp query-max-response-time time
no ip igmp query-max-response-time
ip igmp startup-query-interval time
no ip igmp startup-query-interval
ip igmp startup-query-count count
no ip igmp startup-query-count