Wac User Settings - D-Link xStack DGS-3200-10 User Manual

xStack
Default Redirpath
Clear Default
Redirpath
Click Apply to implement changes made.

WAC User Settings

Users can view and set user accounts for Web authentication.
To view the following window, click Security > Web-based Access Control (WAC) > WAC User Settings:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Enter the URL of the website that authenticated users placed in the VLAN are directed to
once authenticated. This path must be entered into this field before the Web-based Access
Control can be enabled.
Use the radio buttons to specify if the client will be directed to another URL if authenticating
successfully. Click the Yes radio button to redirect the client to the URL specified in the
Default Redirpath field after authenticating successfully. Click the No radio button to not
redirect the client to another URL after successful authentication
NOTE: To enable the Web Authentication function, the redirection path field must
have the URL of the website that users will be directed to once they enter the
limited resource, pre-configured VLAN. Users that attempt to apply settings without
the Redirection Page field set will be prompted with an error message and Web
Authentication will not be enabled. The URL should follow the form
http(s)://www.dlink.com
NOTE: The subnet of the IP address of the authentication VLAN must be the same
as that of the client, or the client will always be denied authentication.
NOTE: A successful authentication should direct the client to the stated web page.
If the client does not reach this web page, yet does not receive a Fail! Message,
the client will already be authenticated and therefore should refresh the current
browser window or attempt to open a different web page.
Figure 5 - 49. WAC User Settings window
167