D-Link xStack DGS-3200-10 User Manual page 45

xStack
Update Time States the specific time the configuration version was downloaded to the Switch.
From States the IP address of the origin of the configuration. There are five ways a configuration may
be downloaded to the Switch. Boot-up files are denoted by an asterisk (*) next to the file.
Console – If the IP address has the word Console next to it, it denotes a configuration upgrade
through the Console Serial Port (RS-232).
Telnet – If the IP address has the word Telnet next to it, it denotes a configuration upgrade
through Telnet.
SNMP – If the IP address has the word SNMP next to it, it denotes a configuration upgrade
through the Simple Network Management Protocol (SNMP).
WEB – If the IP address has the word WEB next to it, it denotes a configuration upgrade through
the web-based management interface.
SSH – If the IP address has the word SSH next to it, it denotes a configuration upgrade using
Secure Shell (SSH).
SIM – If the IP address has the word SIM next to it, it denotes a configuration upgrade through
the Single IP Management feature.
User States the user who downloaded the configuration. This field may read "Anonymous" or
"Unknown" for users that are not identified.
Boot Up States if the configuration will be used to boot up the Switch or not. Yes indicates that the
configuration will be used as the boot up configuration. No indicates that the configuration will not
be used as the boot up configuration.
This parameter is used to boot the Switch up from a configuration stored on an SD card.
Path Name
To boot the Switch from a configuration stored on an SD card carry out the following:
(DGS-3200-24
model only)
Setting the Boot Up Configuration:
Click the Boot button next to the configuration you want to use as the Boot Up configuration.

A Success message appears to indicate that the configuration that will be used for booting up the Switch has changed.

The Boot Up parameter next to the configuration that will be used to boot up the Switch will read Yes.

Setting the Active Configuration:
Click the Active button next to the configuration you want to use as the Active configuration.

A Success message appears to indicate that the configuration that will be used as the active configuration has changed.

An asterisk will appear next to ID of the configuration that is being used as the active configuration.

Deleting a Configuration:
Click the Delete button next to the configuration you want to delete.

A Success message appears to indicate that the configuration has been deleted.

®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch

Input the path of configuration on the SD-card (such as "c:\DGS3200.had").

Click the adjacent Set Boot button to use the configuration, stored on the SD-card, as
the bootup configuration.

Click the adjacent Active button to make the configuration, stored on the SD-card, the
active configuration.
32