D-Link xStack DGS-3200-10 User Manual page 200

xStack
Select ACL Type
IPv6 Class
IPv6 Flow Label
IPv6 Source Address
IPv6 Destination
Address
Click Apply to implement changes made.
To view the setting details for a created profile, click th e Show Details button for the corresponding entry on the Access Profile
List window, revealing the following window:
The window shown below is the Add ACL Profile window for Packet Content:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content. This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each frame's
header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. This flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
The user may specify an IP address mask for the source IPv6 address by ticking the
corresponding check box and entering the IP address mask.
The user may specify an IP address mask for the destination IPv6 address by ticking the
corresponding check box and entering the IP address mask.
Figure 6 - 8. Access Profile Detail Information window for IPv6
187