D-Link xStack DGS-3200-10 User Manual page 99

xStack
To enable IGMP Snooping globally on the Switch:
Click the Enabled radio button.

 Click the Apply button to apply the IGMP Snooping setting.
The following parameters may be viewed in the IGMP Snooping Settings window:
Parameter
VID (VLAN ID)
VLAN Name
Leave Timer
Host Timeout
Router Timeout
State
Parameter Settings
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This specifies the maximum amount of time in seconds between the Switch receiving
a leave group message from a host, and the Switch issuing a group membership
query. If no response to the membership query is received before the Leave Timer
expires, the (multicast) forwarding entry for that host is deleted. The default setting is
2 seconds.
This is the maximum amount of time in seconds allowed for a host to continue
membership in a multicast group without the Switch receiving a host membership
report. Default = 260.
This is the maximum amount of time in seconds a route is kept in the forwarding
table without receiving a membership report. Default = 260.
Select Enabled to implement IGMP Snooping. This field is Disabled by default.
Click the Edit button next to the VLAN you want to edit the IGMP Snooping
parameters for.
86